867 Saw-Cut Loop Kit

Marsh Products' 867 Saw-Cut Vehicle Detector Loop Kit consists of 80 feet of #16 awg wire and loop sealant for the installation of a five-turn loop.

It is ideally suited for vehicle detection in traffic control environments such as drive-thrus or parking lots when connected to the Marsh Products 610 Loop Vehicle Detector.

A concrete saw is used to cut a rectangular pattern in the concrete or asphalt. The kit is intended to be used after pavement installation; if pavement has not been poured, the Marsh Products 865 Preformed Loop is more cost-effective and easier to install.

The kit comes complete with enough wire and sealant to create a five-turn loop measuring 18 by 54 inches. The sealant requires no mixing, dispenses easily with a cartridge gun and is inexpensive to ship by all methods. It is ideal for traffic signals, parking lot gates, drive-thrus and traffic counter control.

Characteristics

• 84 feet of #14 awg machine tool wire for 18-inch-by-54-inch saw cut.
• Single-part polyurethane.
• Does not require mixing.
• Sealant dispenses directly from container with cartridge gun.
• Flexible and tough seal.
• Non-hazardous.
• Can be shipped overseas and by overnight air.
• Withstands corrosive effects of road salts, auto fluids and gasoline.
• Connects directly to the Marsh Products 610 Loop Vehicle Detector.

Contact us now to purchase these products or for more information!

Marsh Products, 336 McKee St., Batavia, Illinois.
Phone: 1.630.879.8008 or 1.800.735.5499; fax: 1.630.879.8072. E-mail: Sales@MarshProducts.com